![]() Click OK again to close the Wireless Network Properties Connection window. Click OK to close the Wireless network properties window, and then click OK again. Select the check box for This is a computer-to-computer (ad hoc) network wireless access points are not used. NOTE: If you have an operating system other than Windows Vista or Windows XP, HP recommends that you use the configuration program that came with your wireless LAN card. Create a network profile for a Windows Vista or Windows XP computer using the directions below. When the setup is finished, you will be prompted to disconnect the USB cable and test the wireless network connection.Ĭhapter 2 To connect the HP Photosmart to a Windows computer with an ad hoc connection, the computer must have a wireless network adapter and an ad hoc profile. If the connection fails, follow the prompts to correct the problem, and then try again. The product will attempt to connect to the network. When you are prompted, connect the product to the computer using the USB setup cable included in the box. ![]() Insert the product Software CD in the computer CD-ROM drive. NOTE: The product begins a timer for approximately two minutes in which the PIN needs to be entered on the networking device. ❑ Enter the PIN on WPS-enabled router or other networking device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |